Thanks Fumbles, there will be a lot of first's for me, a complete scratch build, a large sculpted figure, and connecting a sound board to the plasma disc lol.Nicola Tesla (nearly):-"Billski's imagination may exceed Billski's grasp!"You can be asimulated to
Hi 3rd its going to be roughly 1/6th scale. This is based on the plasma disc being 2.75 inches diameter, which I will reduce to to 2 inches. After research, the size of the drone's head needs to be just over the inch. Based on a ratio of 8:1 the figure will be approx 9 inches tall. The alcove will sit at 12 inches from base to hood. This will sit on a gangway, another 1/2 inch depth. The supporting walls will stretch a further 6 inches either side of the alcove, which should make the total width of 16 inches. I will start the blueprints at sometime this week