Welcome, %1$s. Please login or register. - Did you miss your activation email?

Login with username, password and session length
 

Author Topic: Making the Saucer of the 1/1000 Enterprise Refit Level  (Read 321 times)

Offline ebt12

  • Ensign
  • *
  • Posts: 6
Making the Saucer of the 1/1000 Enterprise Refit Level
« on: February 18, 2018, 09:12:48 am »
Hello all,

I am assembling the 1/1000 Enterprise Refit, and I have found when I attached the lower saucer section it is not level. The right side is lower than the left. I looked at it a few times to make sure it was the saucer and not me. Any tips on making it level? I don't want to tke it off as I am afraid of breaking the small tabs that hold it on. One already broke.

Thanks!

Patrick
Don't turn your back
Don't look away
And don't blink
Good luck!
- The Doctor

Offline starsiegeplayer

  • Admiral
  • *****
  • Posts: 1054
  • In brightest day, in darkest night....
Re: Making the Saucer of the 1/1000 Enterprise Refit Level
« Reply #1 on: February 18, 2018, 11:29:54 am »
Patrick, do you mean the lower saucer is not perpendicular/square with the neck? If so, you could put a couple block-like objects on eitherside of the neck to use as a guide for gluing. 

Offline ebt12

  • Ensign
  • *
  • Posts: 6
Re: Making the Saucer of the 1/1000 Enterprise Refit Level
« Reply #2 on: February 18, 2018, 11:55:04 pm »
Yes, that is what I mean.

Thanks!

Patrick
Don't turn your back
Don't look away
And don't blink
Good luck!
- The Doctor

 




Enterprise © Bloc